ZSPEC "Round Cowl-Clips" Replacement Solution for Z32 300zx, Titanium Fastener Kit w/ Well Nuts

ZSPEC has developed clip-replacement solutions leveraging our famous titanium hardware coupled with Well Nuts. This solution is for the larger Round Clips that hold the Z32 300zx Cowl/Scuttle Panels down. Note, this kit does NOT replace the smaller rectangular clips (replacements are available in a separate listing).

Installation instructions:
1) Remove OE plastic clips and push ZSPEC Well Nuts into Clip Holes on body of vehicle (under cowl panels).
2) Position panels back in place and hand-start each titanium fastener with the included washer.
3) Tighten the fasteners and enjoy. Note, each fastener needs "snugged" in place...the back-side of each well nut will "bulge" holding the panel in place.

Why ZSPEC's Dress Up Bolts® hardware solution?

- Grade-5 Titanium Fasteners and Washers
- Completely reversible (no drilling like others)

Requires basic hand-tools for installation: plastic pry tool to remove clips and #5 hex-key for installation of the ZSPEC hardware (not included).

Fits Z32 300zx, replacing the six (6) LARGE ROUND COWL CLIPS.